Powering The System; Power Off; Sleep Mode - GE Voluson Swift Instructions For Use Manual

Getting started

4.1 Powering the system

Note
Power on

Power off

Info
Info

Sleep Mode

Info
Info
Info
Info
4-2
Caution
Installation and initial start-up of the system must be performed by authorized service
personnel.
Read all safety precautions before using this system.
1. Read 'Electric installation'
system.
2. Connect the Power Cable to the back of the system.
3. Connect the Main Power Cable to a hospital grade power
receptacle with the proper rated voltage.
4. To switch on the system, press the Standby button located to the
left side of the control panel.
5. The system should now go through its boot-up process with no
further user intervention (approximately 2 minutes).
6. After initialization is complete, the default 2D Mode screen is
displayed with the selected probe.
Press the End Exam button before switching off the system. Otherwise current Patient Data as
well as all measurements in the Patient Report will be lost.
1. Press the Standby button on the user interface and select
shutdown in the dialog box.
2. After the system is fully powered off, you may switch off the circuit
breaker located at the rear panel of the console.
•
In case of no system reaction, keep the standby button pressed
for 5 seconds.
•
After shut down, wait for at least 10 seconds before restarting the
system again.
•
The standby button will cut off the electricity to all your connected
peripheral equipment.
•
Double-click the standby button to immediately shutdown the
console.
To use Sleep Mode when do a portable exam in order to reduce the time to start up the
system.
1. Press the Standby button on the user interface and select Sleep.
2. After the Standby button turns to amber color, you may unplug the power cable from the
receptacle.
3. To wake up the system, press the Standby button briefly.
The sleep is only be able to operate during scan mode. Can not be used while other windows
are in use.
System will force Shutdown or Restart after 10 sleeps.
System can boot from sleep both connected and disconnected from AC power.
on page 2-11 before powering on the
Voluson™ SWIFT / Voluson SWIFT+ Instructions For Use
5831612-100 Revision 4