Controls - Disk Unprotected - GE Voluson Swift Instructions For Use Manual

System Setup
Workflow

Controls - Disk unprotected

Info badge
Set unlock password
Retype password
Create unlock keys
Identifier key
Recovery key
Save recovery key
11-20
Figure 11-12 Disk Encryption- unprotected (left image),
protected (right image)
Figure 11-12 Disk Encryption- unprotected (left image),
protected (right image)
1. Set Password
2. Create unlock keys
3. Save or print recovery key and the optional USB key
4. Start encryption
The info badge describes the Disk protection status and follow up steps.
Enter a password with a minimum of 8 characters or numbers.
Retype the password of
If no password is entered this button is disabled.
Create unlock keys to create the USB and recovery keys. The system does a
Press
password validation.
If the password
•
does not match with the retype password, an error message appears and the
password needs to be retyped.
•
is too short, an error message appears and a password with at least 8
characters must be entered.
Created by the system.
Created by the system.
Saves the identifier and recovery key to an external or network device.
Set unlock password .
Voluson™ SWIFT / Voluson SWIFT+ Instructions For Use
5831612-100 Revision 4