System Login And System Lock; Password; Changing The Password - GE Voluson Swift Instructions For Use Manual

Table of Contents

Advertisement

11.1.3 System Login and System Lock

11.1.3.1 Password

Note

Changing the password

Voluson™ SWIFT / Voluson SWIFT+ Instructions For Use
5831612-100 Revision 4
The biopsy lines must be programmed once by the service personnel or the user. The
procedure must be repeated if probes and/or biopsy guides are exchanged!
Before performing a biopsy make sure that the displayed biopsy line coincides with the
needle track (check in a bowl filled with approx. 47˚C warm water). For further
instructions review: 'Biopsy line adjustment for single angle biopsy guide'
'Biopsy line adjustment for multi angle biopsy guide'
Please read the "Instructions for safe Use" in 'Biopsies Safety'
For more information see 'Biopsy line adjustment for single angle biopsy guide' on page
5-23.
For more information see 'Biopsy line adjustment for multi angle biopsy guide' on page 5-
24.
Lock Screen is a security function. It protects the system by password against unwanted
intruders. There are two ways to activate Lock Screen:
Lock button
by pressing the
as soon as the screensaver starts
It is possible to select "Activate User Login" in the System Setup within the tab General
Settings - Authentication. When On is selected, the system is locked after a restart/reboot and
the System Lock screen appears.
With the System lock activated, the system is configured as follows:
All scanning activities are stopped.
All hardkeys are disabled except the trackball, left and right trackball buttons and the
power knob.
The hardware is put into power save.
The screenlock is turned off by:
Correct user password in the password prompt.
Emergency button.
The first time the User Login is enabled, a password has to be created. Therefore the "Change
Password" dialog appears.
1.
Enter the old password.
2.
Enter a new password.
3.
Confirm the new password.
4.
To exit without saving changes press
Save&Exit .
A valid password must be at least 6 characters long and has a maximum length of 80
characters. A password must contain at least 2 non-letter characters, 0...9 or ! @ # $% ^ * ().
1.
To change an existing password press
2.
The "Change Password" dialog appears.
3.
Enter the old and the new password.
4.
Retype the new password and press
on page 5-24
on page 5-20
Exit , to save the changes and exit press
ClearPWD at the System Login.
Save&Exit to save the changes.
System Setup
on page 5-23
11-3

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Voluson Swift and is the answer not in the manual?

This manual is also suitable for:

Voluson swift+

Table of Contents

Save PDF