Worksheet; Changing The Measurement Package; Transferring A Worksheet; Printing A Report - GE Voluson Swift Instructions For Use Manual

10.4 Worksheet

Note
Note
Note
Editing a Worksheet/Report

Changing the Measurement Package

Transferring a Worksheet

Note
Note
Note

Printing a Report

Info
Saving data as PDF
Voluson™ SWIFT / Voluson SWIFT+ Instructions For Use
5831612-100 Revision 4
All calculation results are recorded in the application dependent patient worksheets. By
pressing Report on the control panel , the Worksheet of the selected Measurement Application
is switched on. (Always starts with the first page of worksheet.) According to the selected
measurement application the worksheets display the results of the calculations, graphs,
growth percentile bars and application dependent information available.
It is now possible to switch between Gyn and OB worksheets (if both worksheets exists).
Display depends on the selected measurement package.
If a patient worksheet contains measurements that were performed in the XTD-View mode (),
a yellow caution symbol will be shown in the worksheet header.
Any stored measurements in a patient worksheet can be edited. Move the cursor to the
Set and type in the changes. The edited values are marked with an
desired field, press
asterisk (* next to the changed value). Additionally some parameters or settings can be
changed by clicking into the specific field on the worklist page. For example: Method:
average , minimum, maximum, last or off.
1. To change the measurement package press
2. Select the desired measurement package and press
Transfer Data to transfer the patient worksheet data to the selected destination.
Press
If a Structured Report Server exists, the data is transferred using DICOM Structured
Reporting, independent of whether there are other report servers (network, serial) available.
The Transfer Data key can only be selected if a "Service: REPORT" destination is specified in
the System Setup; To specify a DICOM Address:
Receiving Report Data An example for software that can receive and store reports is the "PIA"
documentation system for medical diagnostics and digital image archiving from "ViewPoint".
(www.viewpoint-online.com)
Print Preview to see how the selected content will appear on the report. The
1. Press
preview can be customized:
1.1. Select the desired measurement package.
Report Format : Standard , Compact A or Compact B .
1.2. Select a
Compact A and Compact B are only available if the check box Use Compact Format is
checked in the Measure Setup.
1.3. Enlarge or reduce the size of the preview by pressing
desired.
1.4. Print the Report: Under
either for the selected measurement package or for all packages.
Print Report to print the report.
2. Press
1. Select Export Report .
Measurements and Calculations
Meas Applicat. .
Return .
Print Report(s) select if the Report should be printed
Zoom In or Zoom Out if
10-21