Moving The System; Operation Safety; Lifting The System - GE Voluson Swift Instructions For Use Manual

Note

2.5 Moving the system

Lifting the system

2.6 Operation safety

Voluson™ SWIFT / Voluson SWIFT+ Instructions For Use
5831612-100 Revision 4
Over the frequency range from 150 kHz to 80 MHz the ultrasound image can be influenced by
electromagnetic effects. The frequencies of effect depend on the specific ultrasound probe.
Influences may typically be visible in the operating frequencies of the probes which are e.g. in
the range of 1 MHz to 20 MHz and to a lesser extent also for other frequencies.
Caution
Be careful when moving the system. Two people are required when moving the system on
inclines. Before moving the system observe the following:
•
Lower the user interface to its minimal height and move it to center position.
•
Secure the monitor and accessories for transport.
•
Use the rear handle to move the system.
•
Remove all obstacles.
•
Move the system slowly and carefully.
•
Avoid collisions with walls or door frames.
•
Always place the system on horizontal ground and engage the caster brakes.
•
Do not move the system when the brakes are engaged.
•
Move the system forward or backward when going up or down inclines. Do not move the
system sideways or diagonally.
Failure to follow these precautions could result in injury, uncontrolled motion and damage.
For further information on user interface and monitor adjustment read .
1. Preparation:
•
Disconnect all probes and transport them separately.
•
Disconnect the ECG cable (if applicable) and transport it separately.
•
Ensure all peripheral devices (printer, ...) are firmly fixed within the system.
2. Have the footrest cover removed by authorized personnel.
3. Pass a strap through the openings in the metal sheet.
4. Lift the system by the straps and the rear handle.
Caution
Always use a strap to lift the system.
•
Do not grasp the metal sheet with your hands.
•
Two people are required when lifting more than 16 kg (35 lbs).
•
Do not lift the system with the back handle of the user interface.
Caution
Installation and initial start-up of the system must be performed by authorized service
personnel.
Safety
2-13