Transmission Disassembly - Polaris RZR XP 1000 2014 Service Manual

TRANSMISSION
TORQUE
Outer Radius Rod Bolts:
40 ft-lb (54 Nm)
25. Install the stabilizer bar link mounting bolts and new
f
nuts . Torque to specification.
TORQUE
Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
26. Safely lower the vehicle.
27. If transmission lubricant was drained, fill the
transmission with the specified amount of Polaris
AGL (see Chapter 2 – Transmission Lubrication,
page 2.27).
FLUID CAPACITY
Recommended Transmission Lubricant:
Capacity (Standard):
44 oz (1300 mL)
Capacity (INT'L):
40.5 oz (1200 mL)
6.12
AGL

TRANSMISSION DISASSEMBLY

Refer to the exploded view at the end of this chapter as
a reference.
1. Place transmission in High gear before disassembly.
2. Drain and properly dispose of the transmission
lubricant (see Chapter 2).
3. Remove the bell crank nut
e
4. Remove E-clip that retains spring and flat washers
r t
and gear switch
5. Remove the sector cover bolts
u
sector cover .
Removal can be aided by using your thumbs to press in
on the shafts while pulling out the cover with your
6. Remove the compression spring
7. Remove the detent star
fits onto the splined shaft with the raised edge facing
outward for reassembly.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
NOTE
q w
and bell crank
. Remove the switch.
y
and remove the
NOTE
fingers.
i
.
o
. Note how the detent star
© Copyright Polaris Industries Inc.
.