Front Bearing Replacement - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

Advertisement

FRONT BEARING REPLACEMENT

Bearing Removal
1. Remove the outer snap ring
2. From the back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the reliefs as
shown.
3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
4. Inspect the bearing carrier housing for scratches,
wear or damage. Replace front bearing carrier if
damaged.
Bearing Installation
5. Thoroughly clean the front bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
7. Apply Loctite
q
.
8. Wipe the housing clean of any excess compound
®
603
retaining compound to the
outer circumference of the new bearing
carefully press the new bearing into the bearing
carrier housing.
NOTE
Use care to not allow any of the Loctite
get in the bearing.
e
and install the snap ring
.
FINAL DRIVE
w
race and
®
compound to
7
7.5

Advertisement

Table of Contents
loading

Table of Contents