Front Gearcase Assembly - Polaris RZR XP 1000 2014 Service Manual

FINAL DRIVE

FRONT GEARCASE ASSEMBLY

1. As mentioned during gearcase disassembly section,
replace all O-rings, seals and worn components.
2. Install pinion shaft assembly and install internal snap
ring.
If bearing replacement was required, press new bearing
onto the pinion shaft and install a new external snap
3. Install a new pinion shaft seal into the pinion gear
housing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.
4. Install the RH output hub into the gearcase housing.
7.40
NOTE
ring.
5. Carefully install the rollers into the roll cage
assembly while installing the assembly into the
clutch housing.
Install roll cage so that the ring gear grooves line up
with the roll cage windows (see below). Be sure role
cage top groove is facing upward.
6. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
NOTE
© Copyright Polaris Industries Inc.