Polaris RZR XP 1000 2014 Service Manual page 422

BRAKE SYSTEM
Caliper Removal
Do not get oil, grease, or fluid on the parking brake
pads. Damage to or contamination of the pads may
cause the pads to function improperly.
1. Remove the clip pin and pin (A) from the parking
brake cable.
Be sure the parking brake is not engaged.
2. Remove the two fasteners (B) retaining the parking
brake caliper mount / shift cable bracket.
3. Lift the parking brake caliper off the brake disc and
remove it from the vehicle.
Caliper Disassembly / Inspection
9.14
NOTE
NOTE
Refer to the "Electronic Parts Catalog" for parking brake
caliper replacement parts information.
1. Remove the two caliper assembly bolts (C).
2. Slide the brake pads and springs from the assembly.
Retain the lever and ball bearings for reassembly.
3. Inspect brake pads for excessive wear. Replace as
needed.
4. Check the three steel balls for any signs of cracking.
Replace as needed.
5. Check ball seats in lever and stationary actuator. If
excessively worn, replace parts as needed.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
NOTE
NOTE
© Copyright Polaris Industries Inc.