Table of Contents
Advertisement
SHOCKS / SPRINGS
SHOCK ASSEMBLY VIEW
q
42 ft-lbs (57 Nm)
w
35 in-lb (4 Nm)
Retainer gap should be 180° from spring end
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
e
70 ft-lbs (95 Nm)
r
14 in-lbs (2 Nm)
STEERING / SUSPENSION
SHOCK REMOVAL / INSTALLATION
1. Elevate the vehicle off the ground to relieve the
suspension load.
2. Support under A-arm or trailing arm.
3. Remove the upper and lower fasteners retaining the
shock and remove the shock from the vehicle.
Discard nuts and replace with new upon installation.
4. Reverse the procedure to reinstall the shock. Torque
new fasteners to specification (see Chapter 8 –
Shock Assembly View, page 8.23 andRear Shock
Assembly View, page
).
TORQUE
Shock Mounting Bolts:
Front:
42 ft-lb (57 Nm)
Rear:
70 ft-lbs (95 Nm)
SHOCK / SPRING REPLACEMENT
1. Remove the shock and note the spring preload
distance (see Chapter 2 – Spring Adjustment
(WALKER EVANS™), page
2. Loosen the jam nut (if applicable) and adjustment
ring until the spring is loose. If needed, use a spring
compressor to compress the spring far enough to
remove the spring retainer.
3. Remove the spring and spring retainer from the
existing shock and install components onto the new
shock.
4. Install the spring(s) and spring retainer.
NOTE
The spring retainer gap should be 180° from the end of
the spring upon installation.
5. Tighten the spring adjustment ring to set the preload
distance noted in Step 1 (see Chapter 2 – Spring
Adjustment (WALKER EVANS™), page
6. Reinstall the shock onto the vehicle and torque new
fasteners to specification.
).
8
).
8.23
Advertisement
Chapters
Table of Contents
Troubleshooting
