Fuel Pump Replacement - Polaris RZR XP 1000 2014 Service Manual

FUEL SYSTEM
9. If the pump still does not operate, check for correct
ECU operation by plugging in a known-good ECU of
the same model.
If the pump still does not operate, replace the fuel pump
assembly.

FUEL PUMP REPLACEMENT

1. Move the vehicle to a well ventilated area. Shift the
transmission into Park and turn the ignition key off.
2. Remove the passenger seat to access the fuel
pump.
WARNING
Always wear safety goggles when working with high
pressure or flammable fluids. Failure to do so could
result in serious injury or complications.
3. Be sure the top of the fuel tank is clean
requires cleaning, hand wash the top of the tank to
ensure no debris will enter the fuel system when the
fuel pump is removed.
WARNING
Failure to clean area around fuel pump may lead to
debris entering the fuel tank during service. Excessive
debris in fuel tank may cause premature wear of fuel
pump and/or clogging of internal fuel filters.
4. Ensure that static has been discharged by touching a
ground source such as the engine or frame.
4.26
NOTE
q
5. While holding a shop towel over the fuel line
connectors, disconnect the fuel supply line
the pump and the fuel return line (B) from the tank
(see Chapter 2 – Fuel Lines, page 2.20 for specific
removal procedures).
It is possible for pressurized fuel to be present when
disconnecting the fuel line.It is recommended to allow
the vehicle to sit for a period of one hour after shutting
off the engine before servicing the fuel pump. This
allows the exhaust to cool and fuel pressure to drop.
A small amount of fuel may come out of the fuel lines or
pump fitting. Properly drain fuel into a suitable
6. Disconnect the fuel pump electrical harness
. If it
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
CAUTION
NOTE
container.
© Copyright Polaris Industries Inc.
w
from
e
.