Polaris RZR XP 1000 2014 Service Manual page 241

12. Remove the drive clutch retaining bolt and remove
the drive clutch using Drive Clutch Puller.
Drive Clutch Puller:
2872085
NOTE
Be sure to use the correct Drive Clutch Puller to prevent
damage to crankshaft.
13. Remove the four push rivets that secure the upper
guard plate to the top of the inner PVT cover. Make
note of the routing of the fuel lines, vent line, battery
cable and wire harness for proper assembly.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
14. Remove the seven bolts
cover to engine and transmission. Remove inner
clutch cover.
PVT ASSEMBLY (2016)
1. Inspect inner clutch cover. Replace if cracked or
damaged.
2. Inspect the seal on the transmission input shaft.
Replace if damaged.
3. Inspect inner clutch cover seal
Replace if cracked, torn or damaged.
4. Apply silicone around all seven screw holes on the
inner clutch cover.
IMPORTANT
DO NOT apply silicone on drive and driven shaft
inner cover donuts.
PVT SYSTEM
r
that retain inner clutch
q
(engine side).
5.15
5