General Information; Special Tools; Torque Specifications; Electrical Service Notes - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

Advertisement

ELECTRICAL

GENERAL INFORMATION

SPECIAL TOOLS

PART NUMBER TOOL DESCRIPTION
Fluke™ 77 Digital Multimeter
PV-43568
PV-43526
Connector Test Kit
Timing Light
2870630
Battery Hydrometer
PU-50338
2460761
Hall Effect Sensor Probe Harness
Static Timing Light Harness
2871745
Battery Conductance Analyzer
PU-50296
(MDX-610P)
Relay Bypass
PU-49466
Digital Wrench® (see Chapter 4 –
-
DIGITAL WRENCH® OPERATION,
page
Bosch Automotive Service Solutions: 1-800-345-2233
or http://polaris.service-solutions.com/

TORQUE SPECIFICATIONS

ITEM
Coolant Temperature
Sensor
Starter Mounting
Fasteners
Oxygen Sensor
11.4
)
TORQUE
17 ft-lb (23 Nm)
7 ft-lb (10 Nm)
13 ft-lb (18 Nm)

ELECTRICAL SERVICE NOTES

Keep the following notes in mind when diagnosing an
electrical problem:
• All EFI component information and diagnostic testing
procedures are located in the Fuel System chapter.
• Always refer to Digital Wrench when diagnosing and
diagnostic trouble code.
• Refer to wiring diagram for stator and electrical
component resistance specifications.
• When measuring resistance of a component that has a
resistance value under 10 Ohms, remember to
subtract meter lead resistance from the reading.
Connect the leads together and record the resistance.
The resistance of the component is equal to tested
value minus the lead resistance.
• Become familiar with the operation of your meter. Be
sure leads are in the proper jack for the test being
performed (i.e. 10A jack for current readings). Refer to
the Owner's Manual included with your meter for more
information.
• Voltage, amperage, and resistance values included in
this manual are obtained with a Fluke™ 77 Digital
Multimeter (PV-43568). This meter is used when
diagnosing electrical problems. Readings obtained
with other meters may differ.
• Pay attention to the prefix on the multimeter reading
(K, M, etc.) and the position of the decimal point.
• For resistance readings, isolate the component to be
tested. Disconnect it from the wiring harness or power
supply.
• Most electrical issues are related to damaged wiring.
Fully test wiring before replacing any components.

UNDER-DASH COMPONENTS

The following switches and components can be
accessed underneath the instrument / dash panel:
• Speedometer
• AWD Switch
• Headlamp Switch
• 12 Vdc Accessory Power Point
• Ignition Switch
• LED Ambiance Light
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.

Advertisement

Table of Contents
loading

Table of Contents