Switches; Brake Light Switch; Headlamp Switch - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

SWITCHES

1. The brake light switch

line banjo bolt of the master cylinder. The brake

switch can be accessed through the left front wheel

well opening.

2. Disconnect wire harness from switch and connect an

ohmmeter across switch contacts. The reading

should be infinite (OL).

3. Apply the brake and check for continuity. If there is

no continuity or if resistance is greater than 0.5

ohms, clean the switch terminals. Re-test and

replace switch if necessary.

4. For switch replacement, refer to Chapter 9 "Brakes".

is located on the front brake

1. Disconnect the headlamp switch harness by

depressing the connector locks and pulling on the

connector. Do not pull on the wiring.

2. Test between the 3 sets of outputs (OFF / LOW /

HIGH). If any of the tests fail, replace headlamp

switch assembly.

• Move the switch to HIGH. There should be continuity

between switch pins 2 and 3; 5 and 6; 7 and 8.

• Move the switch to LOW. There should be continuity

between switch pins 2 and 3; 4 and 5; 7 and 8..

• Move the switch to OFF. There should be continuity

between switch pins 1 and 2; 4 and 5; 7 and 8.

Pins 7 and 8 provide power and ground to light the

switch lamp.

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

Table of Contents