Polaris RZR XP 1000 2014 Service Manual page 485

INSTRUMENT CLUSTER PINOUTS
FUNCTION
CAN High
CAN Low
Switched Power (Vdc)
Constant Power (Vdc)
Ground
High Beam Input
Fuel Level Sensor
Ambient Air Temperature
International Models Only
Turn Signal Input, LH
Turn Signal Input, RH
INSTRUMENT CLUSTER REMOVAL
NOTE
Do not allow alcohol or petroleum products to come in
contact with the instrument cluster lens.
1. Disconnect the wire harness connector from the
back side of the instrument cluster.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
2. Push the instrument cluster
of the dash while securely holding the dash
rubber mount
PIN
1
2
3
Do not remove the rubber mount from the dash panel.
4
Only remove the rubber mount if necessary. The bezel
r
is a snap-on assembly and is a serviceable part.
5
8
INSTRUMENT CLUSTER INSTALLATION
11
1. Spray a soap and water mixture onto the outer
15
surface area of the instrument cluster. This will help
the instrument cluster slide into the rubber mount
more easily.
6
2. Be sure the rubber mount inside the dash is fully
installed and that the indexing key on the rubber
7
mount is lined up with the keyway in the dash.
3. Hold the dash securely and insert the instrument
cluster into the dash. Twist the instrument cluster
gently in a clockwise motion to properly seat the
instrument cluster into the rubber mount. Apply
pressure on the bezel while pressing down on the
instrument cluster.
ELECTRICAL
e
out from the back side
w
.
NOTE
q
and
11
11.11