Headlamp Installation; Taillight Replacement; Dash Light - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

3. Carefully lift and remove headlamp assembly from

HEADLAMP INSTALLATION

1. Install the headlamp adjustment springs onto the

front bumper mounting bosses.

2. Insert the three T-25 headlamp mounting screws into

the headlamp assembly mounting holes.

3. Maneuver the headlamp assembly into position. Be

sure all three headlamp springs

are properly aligned with mounting bosses

on the front bumper.

4. Fully tighten all three headlamp screws until the

headlamp assembly is fully seated. Back headlamp

mounting screws off 1/8" to 1/4" (2-3 turns).

5. Install the front bumper as shown in Chapter 5 if

previously removed.

6. Connect headlamp electrical connector to the

headlamp assembly.

7. Perform the "Headlight Adjustment" procedure as

shown in this chapter.

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

Before replacing the taillight(s), use a digital multi-meter

to test the harness to ensure the lamp is receiving 12

volts and that a ground path is present.

1. Disconnect the wire harness

and mounting

2. While holding the taillight assembly, remove the

remove it from the rear fascia.

The LED light will remain ON for approximately 30

seconds after key has been switched to the OFF

retaining the taillight assembly and

Table of Contents