Wheel Installation; Tire Inspection; Maintenance; Tire Pressure - Polaris RZR XP 1000 2014 Service Manual

WHEEL INSTALLATION

1. Verify the transmission is still in PARK.
2. Place the wheel in the correct position on the wheel
t
hub . Be sure the valve stem
outside and rotation arrows on the tire point toward
forward rotation.
q
3. Attach the wheel nuts and finger tighten them.
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts and/or hub nut
proper torque specification.
TORQUE
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
Hub Castle Nuts:
180 ft-lbs (244 Nm)
6. If hub nut was removed, install a new cotter pin
after the hub nut has been tightened. If the holes do
not line up, turn the hub nut counter-clockwise until
the cotter pin can be installed.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.

TIRE INSPECTION

• Improper tire inflation may affect vehicle
maneuverability.
• When replacing a tire always use original equipment
w
is toward the
size and type.
• The use of non-standard size or type tires may affect
vehicle handling.
Operating with worn tires will increase the possibility of
e
to the
the vehicle skidding easily with possible loss of control.
Always replace tires when the usable tread depth has

TIRE PRESSURE

Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle's
r
tool kit.
Maintain proper tire pressure. Refer to the warning tire
Model
XP
XP4
High Lifter
Desert Edition

MAINTENANCE

WARNING
Worn tires can cause an accident.
worn out.
CAUTION
pressure decal applied to the vehicle.
TIRE PRESSURE INSPECTION (COLD)
Front
16 psi (110 kPa)
19 psi (131 kPa)
18 psi (124 kPa)
16 psi (110 kPa)
2
Rear
16 psi (110 kPa)
21 psi (145 kPa)
18 psi (124 kPa)
24 psi (165 kPa)
2.25