Etc Learn Procedure - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

4. With the ignition turned off, disconnect the wire

harness from the ECU. Lift the connector locking

lever and rotate it up until the connector is free from

Upon removing the ECU connector, you should hear a

"click" when the connector is fully open.

5. To install, reverse the procedure and tighten the

mounting screws to specification.

Upon installing the ECU connector, you should hear a

"click" when the connector is fully closed.

ECU Retaining Screws:

24 in-lb (3 Nm)

ETC LEARN PROCEDURE

This procedure MUST be performed on the vehicle

whenever the ECU is replaced or reflashed or the

throttle body is replaced.

1. After the reflash / ECU replacement / throttle body

change, leave the key on (engine not running) for 60

seconds. Do NOT crank the engine during this time.

2. Turn the key off and wait 3 minutes. During this time,

the ECU will write values into memory and then

completely shut down.

3. Turn key back on and start the vehicle. The vehicle

should operate normally.

4. If the procedure was interrupted at any time, start

back at step 1.

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

Table of Contents