Camshaft Installation / Timing - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

ENGINE / COOLING SYSTEM

7. Install and finger tighten the two outer M6 bolts

Install new cylinder head bolts.

specification.

Cylinder Head Torque Procedure:

Torque in sequence

Step 1: 9 ft-lbs (12 Nm)

Step 2: 26 ft-lb (35 Nm)

Step 3: Additional 180°

Step 4: M6 bolts: 7 ft-lb (10 Nm)

CAMSHAFT INSTALLATION / TIMING

If any valve train components were replaced, refer to

Valve Clearance Adjustment, page 3.85 procedure prior

to Camshaft Installation / Timing, page 3.80.

1. Rotate the engine until the flywheel Top Dead Center

Crankshaft Position Sensor (CPS) mounting hole

This places the PTO cylinder at TDC for camshaft

installation.

DO NOT use the "V" mark located on the flywheel

opposite of the "I" mark. Only the "I" mark should be

used as a TDC reference.

2. Reference the intake and exhaust markings made

during disassembly. If installing new camshafts or if

camshafts were not marked, you can reference the

part number stamped on the end of the shafts and

compare to the electronic parts catalog.

3. Lubricate all camshaft lobes and bearing journal

surfaces with Polaris PS-4 engine oil prior to

installation.

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

is aligned or centered in the

Table of Contents