Polaris RZR XP 1000 2014 Service Manual page 284

TRANSMISSION
15. Remove the input shaft
and idler gear shaft assembly
transmission housing by pulling both assemblies
straight up.
16. Place the gear cluster assembly on a clean surface
for inspection. If disassembly is required, refer to
"Gear Cluster Disassembly".
17. Using a 5 mm Allen wrench, remove the screws that
secure the pinion shaft assembly
shaft assembly straight up to remove it from the
housing. Note the longer screw
snorkel tube.
18. Remove all seals from the gearcase halves and clean
the cases in preparation for assembly.
Gear Cluster Disassembly
6.14
2)
, gear cluster assembly
2@
from the
2#
. Lift the pinion
2 $
that locks the
2!
19. Remove the bearing from the reverse shaft using a
bearing puller. Remove the retaining ring and slide
the washers, high gear and needle bearing off the
reverse shaft.
q
Bearing
w
Reverse Shaft
e
Retaining Ring
r
Washers
t
High Gear
20. Remove the retaining ring and engagement dog from
the reverse shaft.
21. Remove the retaining ring, washer, needle bearing,
and sprocket from the reverse shaft.
22. Tilt the two shafts towards each other and remove the
silent chain from the two shafts.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
y
Needle Bearing
u
Engagement Dog
i
Sprocket
o
Silent Chain
a
Input Shaft
© Copyright Polaris Industries Inc.