Rear Prop Shaft Removal Xp 4 - Polaris RZR XP 1000 2014 Service Manual

FINAL DRIVE
7. Torque the support
specification.
TORQUE
Support Bearing Fasteners:
35 ft-lb (47 Nm)
8. Align the front prop shaft paint mark with the front
gearcase input shaft mark so the pin holes align.
Install a new roll pin.
7.30
bearing fasteners to

REAR PROP SHAFT REMOVAL XP 4

1. Remove all seats.
2. Remove the front and rear center consoles (see
Chapter 10 – Rocker Panels, Rear Console and Floor
XP 4, page 10.24).
3. Remove the fasteners
e
plates .
4. Remove center and rear skid plates.
5. Remove the fasteners
t
bearing cover to the frame.
6. Move the prop shaft support bearing assembly to the
drivers side to slide the rear prop shaft yoke
transmission output shaft.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
q w
from center and rear skid
r
securing the support
y
off the
© Copyright Polaris Industries Inc.