Etc Test; Etc Replacement; Etc Learn Procedure - Polaris RZR XP 1000 2014 Service Manual

ETC TEST

Never attempt to disassemble the ETC assembly.
Warranty is void if the end cover is opened or tampered
with in any way.
All operating and control functions within the ETC are
pre-set. No internal servicing or adjustments may be
performed. If a problem is encountered, and you
determine the ETC to be faulty, contact the Polaris
Service Department for specific handling instructions. Do
not replace the ETC without factory authorization.
Use Digital Wrench® to perform all troubleshooting of
this component. Use a Volt Ohm meter to test the vehicle
harness continuity between the ETC connector and ECU
connector. Refer to the wire diagram for pin-out details. If
the ETC is faulty, the entire ETC assembly must be
replaced (see ETC / Throttle Body Replacement, page
).
If code P1227 is being set, verify the following:
1. Check power supply voltage on pin for Pedal
2. Verify voltage at pedal for supply line. Troubleshoot
wiring
3. Check the pedal for sensor/physical damage (circuit
fault). Troubleshoot pedal 1 and 2 vs each other
(depending on faults)

ETC REPLACEMENT

1. Remove the cargo box access panel.
2. Remove wire harness from the ETC
3. Remove the four bolts retaining the ETC housing to
intake plenum.
4. Remove the ETC housing and gasket from intake
plenum.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
5. Reverse these steps for installation. Torque the ETC
housing retaining bolts and intake boot clamp to
specification.

ETC LEARN PROCEDURE

This procedure MUST be performed on the vehicle
whenever the ECU is replaced or reflashed or the
1. After the reflash / ECU replacement / throttle body
change, leave the key on (engine not running) for 60
seconds. Do NOT crank the engine during this time.
2. Turn the key off and wait 3 minutes. During this time,
the ECU will write values into memory and then
completely shut down.
3. Turn key back on and start the vehicle. The vehicle
should operate normally.
4. If the procedure was interrupted at any time, start
q
.
back at step 1.
FUEL SYSTEM
TORQUE
ETC Housing Retaining Bolts:
7 ft-lb (10 Nm)
Intake Boot Clamp:
35 in-lb (4 Nm)
IMPORTANT
throttle body is replaced.
4
4.35