Rear Drive Shaft Installation - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

11. Leaving the drive shaft in the transmission, swing the

rear trailing arm assembly outward until it is free from

the rear drive shaft.

12. Lower the trailing arm.

13. With a short, sharp jerk, remove drive shaft from the

transmission splines.

REAR DRIVE SHAFT INSTALLATION

1. Install new spring ring

anti-seize compound to the splines

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

2. Align splines of drive shaft with transmission splines

3. Swing the rear trailing arm assembly outward and

4. Install the lower shock mounting bolt and new nut.

on drive shaft. Apply an

5. Install the stabilizer bar mounting bolt, washer and

6. Apply Anti-Seize to drive shaft axle splines.

and reinstall the drive shaft. Use a rubber mallet to

tap on the outboard end of the drive shaft if

upward until the rear axle can be inserted into the

bearing carrier. Support the trailing arm from

Torque fastener to specification.

Lower Shock Bolt to Trailing Arm:

70 ft-lbs (95 Nm)

new nut. Torque fastener to specification.

Stabilizer Bar Linkage:

40 ft-lbs (54 Nm)

Table of Contents