12. RS-232 Operation
Firmware Upgrade Command
The available formula for the Firmware Upgrade command is as follows:
Command + Control + [Enter]
For example, to enable firmware upgrade mode, type the following:
upgrade on [Enter]
12.4.12 KVM Status
The KVM Status command allows you to display read-only information about the KVM's current configuration status.
The default setting is off.
Use the Formula → to set Parameters → to create a Command.
Formula
Command + Control + [Enter]
Parameters
Command
status
Control
on
Enter
Enter
KVM Status Command
The available formula for the KVM Status command is as follows:
Command + Control + [Enter]
For example, to display the configuration status for the B024-H4U08 / B024-H4U16, type the following:
status on [Enter]
A message similar to the one below will then appear:
hotkey: [numlock]+[-] / [scrolllock],[scrolllock]
os setting: pc
keyboard emulation: enabled/disabled
keyboard layout: English
mouse emulation: enabled/disabled
monitor re-detection: enabled/disabled
Description
KVM Status command
Description
Enable KVM status
Description
Enter and send out command
53