MEMory
Subsystem Syntax
Note
Use Sequence
Note
MEMory:VME:ADDRess
216 HP E1415 Command Reference
The MEMory subsystem allows using VME memory as an additional reading storage
buffer.
MEMory
:VME
:ADDRess < A24_address >
:ADDRess?
:SIZE < mem_size >
:SIZE?
:STATe 1 | 0 | ON | OFF
:STATe?
This subsystem is only available in systems using an HP E1405B or HP E1406A
command module.
*RST
MEM:VME:ADDR #H300000
MEM:VME:SIZE #H100000
MEM:VME:STAT ON
*
*(set up E1415 for scanning)
*
TRIG:SOUR IMM
INIT
*OPC?
FORM REAL,64
FETCH?
When using the MEM subsystem, the module must be triggered before executing the
INIT command (as shown above) unless you are using an external trigger (EXT
trigger). When using EXT trigger, the trigger can occur at any time.
MEMory:VME:ADDRess < A24_address >
memory card to be used as additional reading storage.
1M byte or 262144 readings
let unit trigger on INIT
program execution remains here until
VME memory is full or the HP E1415 has
stopped taking readings
affects only the return of data
return data from VME memory
sets the A24 address of the VME
Chapter 6