Table of Contents
Advertisement
CALibration
Chapter 6
The Calibration subsystem provides for two major categories of calibration.
1. "A/D Calibration"; In these procedures, an external multimeter is used to
calibrate the A/D gain on all 5 of its ranges. The multimeter also determines
the value of the HP E1415's internal calibration resistor. The values generated
from this calibration are then stored in nonvolatile memory and become the
basis for "Working Calibrations. These procedures each require a sequence of
several commands from the CALibration subsystem (CAL:CONFIG...,
CAL:VALUE..., and CAL:STORE ADC). Always execute *CAL? or a
CAL:TARE operation after A/D Calibration.
2. "Working Calibration", of which there are three levels (see Figure 6-3):
-- "A/D Zero"; This function quickly compensates for any short term A/D
converter offset drift. This would be called the auto-zero function in a
conventional voltmeter. In the HP E1415 where channel scanning speed is
of primary importance, this function is performed only when the
CAL:ZERO? command is executed. Execute CAL:ZERO? as often as your
control setup will allow.
-- "Channel Calibration"; This function corrects for offset and gain errors for
each module channel. The internal current sources are also calibrated. This
calibration function corrects for thermal offsets and component drift for
each channel out to the input side of the Signal Conditioning Plug-On
(SCP). All calibration sources are on-board and this function is invoked
using either the *CAL? or CAL:SETup command.
-- "Channel Tare"; This function (CAL:TARE) corrects for voltage offsets in
external system wiring. Here, the user places a short across transducer
wiring and the voltage that the module measures is now considered the new
"zero" value for that channel. The new offset value can be stored in
non-volatile calibration memory (CAL:STORE TARE) but is in effect
whether stored or not. System offset constants which are considered
long-term should be stored. Offset constants which are measured relatively
often would not require non-volatile storage. CAL:TARE automatically
executes a *CAL?
HP E1415 Command Reference
185
Advertisement
Table of Contents
