Table of Contents
Advertisement
CALibration
CALibration:SETup
Comments
Usage
CALibration:SETup?
Comments
Usage
188 HP E1415 Command Reference
CALibration:SETup
causes the Channel Calibration function to be performed for
every module channelwith an analog SCP installed (input or output). The Channel
Calibration function calibrates the A/D Offset, and the Gain/Offset for these analog
channels. This calibration is accomplished using internal calibration references. For
more information see *CAL? on page 287.
•
CAL:SET performs the same operation as the *CAL? command except that
since it is not a query command it doesn't tie-up the C-SCPI driver waiting for
response data from the instrument. If you have multiple HP E1415s in your
system you can start a CAL:SET operation on each and then execute a
CAL:SET? command to complete the operation on each instrument.
•
Related Commands: CAL:SETup?, *CAL?
•
When Accepted: Not while INITiated
CAL:SET
:
CAL:SET
CAL:SET?
:
CAL:SET?
Returns a value to indicate the success of the last CAL:SETup
CALibration:SETup?
or *CAL? operation. CAL:SETup? returns the value only after the CAL:SETup
operation is complete.
•
Returned Value:
Value
0
-1
-2
The C-SCPI type for this returned value is int16.
•
Related Commands: CAL:SETup, *CAL?
see CAL:SETup
start SCP Calibration on 1st HP E1415
start SCP Calibration on more
HP E1415s
start SCP Calibration on last HP E1415
query for results from 1st HP E1415
query for results from more HP E1415s
query for results from last HP E1415
Meaning
Cal OK
Cal Error
Query the Error Queue (SYST:ERR?)
See Error Messages in Appendix B
No results available
No *CAL? or CAL:SETUP done
Further Action
None
page 335. Also run *TST?
Chapter 6
Advertisement
Table of Contents
