Table of Contents
Advertisement
Usage
STATus:QUEStionable:ENABle
Parameters
Comments
Usage
STATus:QUEStionable:ENABle?
Comments
Chapter 6
STAT:QUES:ENABLE?
•
*RST Condition: Bit 13, "Setup Changed" is set to 1
STATUS:QUESTIONABLE:CONDITION?
STATus:QUEStionable:ENABle < enable_mask >
that will enable corresponding bits from the Event register to set the Questionable
summary bit.
Parameter
Parameter
Name
Type
enable_mask
numeric (uint16)
•
Enable_mask may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
•
VXI Interrupts: When bits 9, 10, or 11 are enabled and C-SCPI overlap mode
is on (or if you are using non-compiled SCPI), VXI card interrupts will be
enabled. When the event corresponding to bit 9, 10, or 11 occurs, the card
will generate a VXI interrupt.
•
Related Commands: *STB?, SPOLL, STAT:QUES:COND?,
STAT:QUES:EVENT?, STAT:QUES:ENABLE?
•
Cleared By: STAT:PRESet and power-on.
•
*RST Condition: No change
STAT:QUES:ENABLE 128
STATus:QUEStionable:ENABle?
Enable register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
•
Related Commands: *STB?, SPOLL, STAT:QUES:COND?,
STAT:QUES:EVENT?, STAT:QUES:ENABLE
•
*RST Condition: No change
Enter statement will return value from
condition register
sets bits in the Enable register
Range of
Values
0-32767
Set bit 7 in the Questionable Enable
register
returns the value of bits set in the Questionable
HP E1415 Command Reference
STATus
Default
Units
none
275
Advertisement
Table of Contents
