Table of Contents
Advertisement
DIAGnostic
Subsystem Syntax
DIAGnostic:CALibration:SETup[:MODE]
Parameters
Chapter 6
The DIAGnostic subsystem allows you to perform special operations that are not
standard in the SCPI language. This includes checking the current revision of the
Control Processor's firmware, and that it has been properly loaded into Flash Memory.
DIAGnostic
:CALibration
:SETup
:MODE 0 | 1
:MODE?
:TARe
[:OTD]
:MODE 0 | 1
:MODE?
:CHECksum?
:CUSTom
:LINear < table_range >,< table_block >,(@< ch_list >)
:PIECewise < table_range >,< table_block >,(@< ch_list >)
:REFerence
:TEMPerature
:FLOor[:CONFigure] <range>,(@ch_list>)
:DUMP
:IEEE 1 | 0
:IEEE?
:INTerrupt
[:LINe] < intr_line >
[:LINe]?
:OTDetect
[:STATe] 1 | 0 | ON | OFF,(@< ch_list >)
[:STATe]? (@< channel >)
:QUERy
:SCPREAD? < reg_addr >
:VERSion?
DIAGnostic:CALibration:SETup[:MODE] < mode >
use for analog output SCPs like the HP E1531 and HP E1532 when *CAL? or
CAL:SET are executed.
Parameter
Parameter
Name
Type
mode
boolean (uint 16)
sets the type of calibration to
Range of
Values
0 | 1
HP E1415 Command Reference
Default
Units
volts
195
Advertisement
Table of Contents
