STATus:OPERation:ENABle?
Comments
Usage
STATus:OPERation[:EVENt]?
Comments
Usage
STATus:OPERation:NTRansition
Chapter 6
STATus:OPERation:ENABle?
register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
•
Related Commands: *STB?, SPOLL, STAT:OPER:COND?,
STAT:OPER:EVENT?, STAT:OPER:ENABLE
•
*RST Condition: No change
STAT:OPER:ENABLE?
STATus:OPERation[:EVENt]?
the Event register.
•
When using the Operation Event register to cause SRQ interrupts,
STAT:OPER:EVENT? must be executed after an SRQ to re-enable future
interrupts.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
•
Related Commands: *STB?, SPOLL, STAT:OPER:COND?,
STAT:OPER:ENABLE, STAT:OPER:ENABLE?
•
Cleared By: *CLS, power-on, and by reading the register.
•
*RST Condition: No change
STAT:OPER:EVENT?
STAT:OPER?
STATus:OPERation:NTRansition < transition_mask >
Transition Filter (NTF) register. When a bit in the NTF register is set to one, the
corresponding bit in the Condition register must change from a one to a zero in order
to set the corresponding bit in the Event register. When a bit in the NTF register is
zero, a negative transition of the Condition register bit will not change the Event
register bit.
returns the value of bits set in the Operation Enable
Enter statement returns current value of
bits set in the Operation Enable register
returns the decimal weighted value of the bits set in
Enter statement will return the value of
bits set in the Operation Event register
Same as above
HP E1415 Command Reference
STATus
sets bits in the Negative
271