Table of Contents
Advertisement
INPut
Comments
Usage
INPut:FILTer[:LPASs][:STATe]?
Parameters
Comments
Usage
INPut:GAIN
Parameters
Comments
212 HP E1415 Command Reference
•
If the SCP has not yet been programmed, ON enables the SCP's default cutoff
frequency.
•
When Accepted: Not while INITiated
•
*RST Condition: ON
INPUT:FILTER:STATE ON,(@115,117)
INP:FILT OFF,(@100:115)
INPut:FILTer[LPASs][:STATe]? (@< channel >)
filtering for the specified channel. If the channel is not on an input SCP, the query
will return zero.
Parameter
Parameter
Name
Type
channel
channel list (string)
•
Returned Value: Numeric value either 0 (off or "pass-through") or 1 (on). The
C-SCPI type is int16.
•
channel must specify a single channel only.
INPUT:FILTER:LPASS:STATE? (@115)
INP:FILT? (@115)
INPut:GAIN < gain >,(@< ch_list >)
Signal Conditioning Plug-Ons.
Parameter
Parameter
Name
Type
gain
numeric (float32)
discrete (string)
ch_list
channel list (string)
•
A programmable amplifier SCP has a choice of several discrete gain settings.
The gain set will be the one closest to the value specified by gain. Refer to
your SCP manual for specific information on the SCP you are programming.
Sending MAX will program the highest gain available with the SCP installed.
Channels 115 and 117 return to
previously set (or default) cutoff
frequency
Set channels 0-15 to "pass-through" state
returns the currently set state of
Range of
Values
100 - 163
Enter statement returns either 0 or 1
Same as above
sets the channel gain on programmable amplifier
Range of
Values
see comment |
MIN | MAX
100 - 163
Default
Units
none
Default
Units
none
none
Chapter 6
Advertisement
Table of Contents
