Table of Contents
Advertisement
Parameters
Comments
Usage
STATus:OPERation:PTRansition?
Comments
Usage
STATus:PRESet
Comments
Chapter 6
Parameter
Parameter
Name
Type
transition_mask
numeric (uint16)
•
transition_mask may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
•
If both the STAT:OPER:PTR and STAT:OPER:NTR registers have a
corresponding bit set to one, any transition, positive or negative will set the
corresponding bit in the Event register.
•
If neither the STAT:OPER:PTR or STAT:OPER:NTR registers have a
corresponding bit set to one, transitions from the Condition register will have
no effect on the Event register.
•
Related Commands: STAT:OPER:PTR?, STAT:OPER:NTR
•
Set to all ones by: STAT:PRESet and power-on.
•
*RST Condition: No change
STAT:OPER:PTR 16
STATus:OPERation:PTRansition?
Transition Filter (PTF) register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
•
Related Commands: STAT:OPER:PTR
•
*RST Condition: No change
STAT:OPER:PTR?
sets the Operation Status Enable and Questionable Data Enable
STATus:PRESet
registers to 0. After executing this command, none of the events in the Operation
Event or Questionable Event registers will be reported as a summary bit in either the
Status Byte Group or Standard Event Status Group. STATus:PRESet does not clear
either of the Event registers.
•
Related Commands: *STB?, SPOLL, STAT:OPER:ENABLE,
Range of
Values
0-32767
When "Measuring" bit goes true, set bit 4
in Status Operation Event register.
returns the value of bits set in the Positive
Enter statement returns current value of
bits set in the PTF register
HP E1415 Command Reference
STATus
Default
Units
none
273
Advertisement
Table of Contents
