Table of Contents
Advertisement
STATus
Parameters
Comments
Usage
STATus:OPERation:NTRansition?
Comments
Usage
STATus:OPERation:PTRansition
272 HP E1415 Command Reference
Parameter
Parameter
Name
Type
transition_mask
numeric (uint16)
•
transition_mask may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
•
If both the STAT:OPER:PTR and STAT:OPER:NTR registers have a
corresponding bit set to one, any transition, positive or negative will set the
corresponding bit in the Event register.
•
If neither the STAT:OPER:PTR or STAT:OPER:NTR registers have a
corresponding bit set to one, transitions from the Condition register will have
no effect on the Event register.
•
Related Commands: STAT:OPER:NTR?, STAT:OPER:PTR
•
Cleared By: STAT:PRESet and power-on.
•
*RST Condition: No change
STAT:OPER:NTR 16
STATus:OPERation:NTRansition?
Transition Filter (NTF) register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
•
Related Commands: STAT:OPER:NTR
•
*RST Condition: No change
STAT:OPER:NTR?
STATus:OPERation:PTRansition < transition_mask >
Transition Filter (PTF) register. When a bit in the PTF register is set to one, the
corresponding bit in the Condition register must change from a zero to a one in order
to set the corresponding bit in the Event register. When a bit in the PTF register is
zero, a positive transition of the Condition register bit will not change the Event
register bit.
Range of
Values
0-32767
When "Measuring" bit goes false, set bit 4
in Status Operation Event register.
returns the value of bits set in the Negative
Enter statement returns current value of
bits set in the NTF register
sets bits in the Positive
Default
Units
none
Chapter 6
Advertisement
Table of Contents
