HP VXI 75000 C Series User's And Scpi Programming Manual page 97

Bit Bit Value
8 256
9 512
10 1024
11 2048
12 4096
13 8192
Bit Bit Value
0 1
4 16
8 256
9 512
10 1024
11 2048
Bit Bit Value
0 1
1 2
2 4
3 8 Device Dependent Error
4 16
5 32
6 64
7 128
Chapter 3
Status Bit Descriptions
Questionable Data Group
Event Name
Lost Calibration At *RST or Power-on Control Processor has found a checksum error in the
Calibration Constants. Read error(s) with SYST:ERR? command and re-calibrate
areas that lost constants.
Trigger Too Fast Scan not complete when another trigger event received.
FIFO Overflowed Attempt to store more than 65,024 values in FIFO.
Overvoltage If the input protection jumper has not been cut, the input relays have been opened
(Detected on Input) and *RST is required to reset the module. Overvoltage will also generate an error.
VME Memory The number of values taken exceeds VME memory space.
Overflow
Setup Changed Channel Calibration in doubt because SCP setup may have changed since last
*CAL? or CAL:SETup command. (*RST always sets this bit.)
Operation Status Group
Event Name
Calibrating Set by CAL:TARE, and CAL:SETup. Cleared by CAL:TARE?, and CAL:SETup?.
Set while *CAL? executing, then cleared.
Measuring Set when instrument INITiated. Cleared when instrument returns to Trigger Idle
State.
Scan Complete Set when each pass through a Scan List is completed
SCP Trigger Reserved for future HP SCPs
FIFO Half Full FIFO contains at least 32,768 values
Algorithm Interrupt The interrupt() function was called in an executing algorithm
Standard Event Group
Event Name
Operation Complete *OPC command executed and instrument has completed all pending operations.
Request Control Not used by HP E1415
Query Error Attempting to read empty output queue or output data lost.
A device dependent error occurred. See Appendix B page 335.
Execution Error Parameter out of range! or instrument cannot execute a proper command because
it would conflict with another instrument setting.
Command Error Unrecognized command or improper parameter count or type.
User Request Not used by HP E1415
Power-On Power has been applied to the instrument
Description
Description
Description
Programming the HP E1415 for PID Control 97