Table of Contents
Advertisement
CALibration
Command
Sequence
CALibration:TARE?
Command
Sequence
CALibration:VALue:RESistance
Parameters
Comments
192 HP E1415 Command Reference
CAL:TARE:RESET
CAL:STORE TARE
CALibration:TARE?
Returns a value to indicate the success of the last CAL:TARE
operation. CAL:TARE? returns the value only after the CAL:TARE operation is
complete.
•
Returned Value:
Value
0
-1
-2
The C-SCPI type for this returned value is int16.
•
Executing CAL:TARE sets the Calibrating bit (bit 0) in Operation Status
Group. Executing CAL:TARE? resets the bit.
•
Related Commands: CAL:STOR TARE
CAL:TARE < ch_list >
CAL:TARE?
CAL:STORE TARE
CALibration:VALue:RESistance < ref_ohms >
the on-board reference resistor to the module for A/D calibration.
Parameter
Parameter
Name
Type
ref_ohms
numeric (float32)
•
ref_ohms must be within 5% of the nominal reference resistor value (7,500
Ohms) and may be specified in Kohm (kohm).
•
A four-wire measurement of the resistor can be made with an external
to reset channel offsets
Optional if necessary to reset tare cal
constants in Flash Memory.
Meaning
Cal OK
Cal Error
Query the Error Queue (SYST:ERR?)
See Error Messages in Appendix B
No results available
to correct channel offsets
to return the success flag from the
CAL:TARE operation
Optional depending on necessity of long
term storage
sends the just-measured value of
Range of
7,500 ± 5%
Further Action
None
page 335. Also run *TST?
Perform CAL:TARE
before CAL:TARE?
Default
Value
Units
ohms
Chapter 6
Advertisement
Table of Contents
