Table of Contents
Advertisement
Category
Command
Calibration
*CAL?
Internal Operation
*IDN?
*RST
*TST?
Status Reporting
*CLS
*ESE <mask>
*ESE?
*ESR?
*SRE <mask>
*SRE?
*STB?
Macros
*DMC <name>,<cmd_data>
*EMC 1 | 0
*EMC?
*GMC? <name>
*LMC?
*PMC
*RMC <name>
Synchronization
*OPC
*OPC?
*TRG
*WAI
Chapter 6
IEEE-488.2 Common Command Quick Reference
Title
Calibrate
Identification
Reset
Self Test
Clear Status
Event Status Enable
Event Status Enable query
Event Status Register query
Service Request Enable
Service Request Enable query
Read Status Byte query
Define Macro Command
Enable Macro Command
Enable Macros query
Get Macro query
Learn Macro query
Purge Macro Commands
Remove Individual Macro
Operation Complete
Operation Complete query
Trigger
Wait to Complete
Command Quick Reference
Description
Performs internal calibration on all 64 channels out to the
terminal module connector. Returns error codes or 0 for OK
Returns the response:
HEWLETT-PACKARD,E1415B,<serial#>,<driver rev#>
Resets all scan lists to zero length and stops scan triggering.
Status registers and output queue are unchanged.
Performs self test. Returns 0 to indicate test passed.
Clears all status event registers and so their status summary bits
(except the MAV bit).
Set Standard Event Status Enable register bits mask.
Return current setting of Standard Event Status Enable register.
Return Standard Event Status Register contents.
Set Service Request Enable register bit mask.
Return current setting of the Service Request Enable register.
Return current Status Byte value.
Assigns one, or a sequence of commands to a macro.
Enable/Disable defined macro commands.
Returns 1 for macros enabled, 0 for disabled.
Returns command sequence for named macro.
Returns comma-separated list of defined macro names
Purges all macro commands
Removes named macro command.
Standard Event register's Operation Complete bit will be 1 when
all pending device operations have been finished.
Places an ASCII 1 in the output queue when all pending
operations have finished.
Trigger s module when TRIG:SOUR is HOLD.
HP E1415 Command Reference
303
Advertisement
Table of Contents
