Table of Contents
Advertisement
Command Quick Reference
Command
:TARE (@<ch_list>)
:RESet
:TARE?
CALibration (cont.)
:VALue
:RESistance <ref_ohms>
:VOLTage <ref_volts>
:ZERO?
DIAGnostic
:CALibration
:SETup
[:MODE] 0 | 1
[:MODE]?
:TARe
[:OTD]
[:MODE] 0 | 1
[:MODE]?
:CHECksum?
:COMMand
:SCPWRITE <reg_addr>,<reg_data>
:CUSTom
:LINear <table_ad_range>,<table_block>,(@<ch_list>)
:PIECewise <table_ad_range>,<table_block>,(@<ch_list>)
:REFerence:TEMPerature
:FLOor <range>,(@<ch_list>)
:DUMP
:INTerrupt[:LINe] <intr_line>
:INTerrupt[:LINe]?
:OTDetect[:STATe] ON | OFF, (@<ch_list>)
:OTDetect[:STATe]? (@<channel>)
:QUERy
:SCPREAD? <reg_addr>
:VERSion?
FETCh?
FORMat
[:DATA] <format>[, <size>]
ASCii[, 7]
PACKed[, 64]
REAL[, 32]
REAL, 64
[:DATA]?
INITiate
[:IMMediate]
298 HP E1415 Command Reference
SCPI Command Quick Reference
Calibrate out system field wiring offsets
Resets cal constants from CAL:TARE back to zero for all channels
Returns state of CAL:TARE operation (returns error codes or 0 for OK)
Send to instrument the value of just measured reference resistor
Send to instrument the value of just measured voltage reference
Correct A/D for short term offset drift (returns error codes or 0 for OK)
Set analog DAC output SCP calibration mode
Return current setting of DAC calibration mode
Set mode to control OTD current during tare calibration
Return current setting of OTD control during tare calibration
Perform checksum on Flash RAM and return a '1' for OK, a '0' for corrupted
or deleted memory contents
Writes values to SCP registers
Loads linear custom EU table
Loads piecewise custom EU table
Puts the contents of the Reference Temperature Register into the FIFO
Sets the lowest range that autorange can select for the specified channels
Places the autorange floor value for all 64 channels into the FIFO
Sets the VXIbus interrupt line the module will use
Returns the VXIbus interrupt line the module is using
Controls "Open Transducer Detect" on SCPs contained in <ch_list>
Returns current state of OTD on SCP containing <channel>
Returns value from an SCP register
Returns manufacturer, model, serial#, flash revision #, and date
e.g. HEWLETT-PACKARD,E1415B,US34000478,A.04.00,
Wed Jul 08 11:06:22 MDT 1994
Return readings stored in VME Memory (format set by FORM cmd)
Set format for response data from [SENSe:]DATA?
Seven bit ASCII format (not as fast as 32-bit because of conversion)
Same as REAL, 64 except NaN, +INF, and -INF formated for HP BASIC
IEEE 32-bit floating point (requires no conversion so is fastest)
IEEE 64-bit floating point (not as fast as 32-bit because of conversion)
Returns format: REAL, +32 | REAL, +64 | PACK, +64 | ASC, +7
Put module in Waiting for Trigger state (ready to make one scan)
Description
Chapter 6
Advertisement
Table of Contents
