Table of Contents
Advertisement
Installing Signal
The following illustrations show the steps you'll use to install Signal
Conditioning Modules. Before you install your SCPs, you should read the
Conditioning
"Separating Digital and Analog SCP Signals" in Appendix E page 361.
Plug-ons
Caution
Use approved Static Discharge Safe handling procedures
anytime you have the covers removed from the HP E1415 or are
handling SCPs.
Installing SCPs: Step 1, Removing the Cover E1415
2
Remove the SCP
1
Retaining Screws
Remove 2 screws (#10 Torx);
lift front and slide out tabs
E1520 REMVLEFT
Chapter 1
Getting Started
21
Advertisement
Table of Contents
