Table of Contents
Advertisement
Appendix B
3032
'0x1: DSP-Unrecognized command code'.
3033
'0x2: DSP-Parameter out of range'.
3034
'0x4: DSP-Flash rom erase failure'.
3035
'0x8: DSP-Programming voltage not present'.
3036
'0x10: DSP-Invalid SCP gain value'. Check that SCP is
seated or replace SCP. Channel numbers are in FIFO.
3037
'0x20: DSP-Invalid *CAL? constant or checksum.
*CAL? required.'.
3038
'0x40: DSP-Couldn't cal some channels'. Check that
SCP is seated or replace SCP. Channel numbers are in
FIFO.
3039
'0x80: DSP-Re-Zero of ADC failed'.
3040
'0x100: DSP-Invalid Tare CAL constant or checksum'.
Perform CAL:TARE - CAL:TARE? procedure.
3041
'0x200: DSP-Invalid Factory CAL constant or
checksum'. Perform A/D Cal procedure.
3042
'0x400: DSP-DAC adjustment went to limit'. Execute
*TST?
3043
'0x800: DSP Status--Do *CAL?'.
3044
'0x1000: DSP-Overvoltage on input'.
3045
'0x2000: DSP-cal constant out of range'. Execute
*CAL?
3046
'0x4000: DSP-ADC hardware failure'.
3047
'0x8000: DSP-reserved error condition'.
3048
'Calibration or Test in Process'.
3049
'Calibration not in Process'.
3050
'ZERO must be sent before FSCale'. Perform A/D Cal
sequence as shown in Command Reference under
CAL:CONF:VOLT
3051
'Memory size must be multiple of 4'. From
MEM:VME:SIZE. Each HP E1415 reading requires 4
bytes.
Error Messages
337
Advertisement
Table of Contents
