[Sense:]Channel:settling; [Sense:]Channel:settling <Num_Samples>,<Ch_List; [Sense:]Channel:settling? <Channel - HP VXI 75000 C Series User's And Scpi Programming Manual

[SENSe]

[SENSe:]CHANnel:SETTling

Parameters
Comments
Usage
[SENSe:]CHANnel:SETTling?
234 HP E1415 Command Reference
:UNSTrained? (@< channel >)
TOTalize:RESet:MODE INIT | TRIGger,(@< ch_list >)
TOTalize:RESet:MODE? (@< channel >)
[SENSe:]CHANnel:SETTling < num_samples >,< ch_list >
measurement samples to make on channels in <ch_list>. SENS:CHAN:SETTLING
is used to provide additional settling time only to selected channels that might need
it. See "Settling Characteristics" on page 110.
Parameter Parameter
Name Type
settle_time numeric (int16)
ch_list string
•
SENS:CHAN:SETTLING causes each channel specified in <ch_list> that is
also referenced in an algorithm to appear <num_samples> times in the analog
input Scan List. Channels that do not appear in any SENS:CHAN:SETT
command will be entered into the scan list only once when referenced in an
algorithm.
•
Since the scan list is limited to 64 entries, an error will be generated if the
number of channels referenced in algorithms plus the additional entries from
any SENS:CHAN:SETTLING commands that coincide with algorithm
referenced channels exceeds 64.
•
The SAMPLE:TIMER command can change the effect of the
SENS:CHAN:SETTLING command since SAMPLE:TIMER changes the
amount of time for each measurement sample.
•
When Accepted: Not while INITiated
•
Related Commands: [SENSe:]CHANnel:SETTling?, SAMPLE:TIMER
•
*RST Condition: SENS:CHAN:SETTLING 1,(@100:163)
SENS:CHAN:SETT 4,(@144,156)
[SENSe:]CHANnel:SETTling? < channel >
to make on <channel>.
specifies the number of
Range of
Values
1 to 64
100 - 163
settle channels 44 and 56 for 4
measurement periods
returns the current number of samples
Default
Units
none
none
Chapter 6