HP VXI 75000 C Series User's And Scpi Programming Manual page 268

STATus
Initializing the
Status System
STAT:PRESET
Subsystem Syntax
268 HP E1415 Command Reference
The following table shows the effect of Power-on, *RST, *CLS and STATus:PRESet
on the status system register settings.
SCPI
Transition
Filters
Power-on preset
*RST none
*CLS none
preset
STATus
:OPERation
:CONDition?
:ENABle < enable_mask >
:ENABle?
[:EVENt]?
:NTRansition < transition_mask >
:NTRansition?
:PTRansition < transition_mask >
:PTRansition?
:PRESet
:QUEStionable
:CONDition?
:ENABle < enable_mask >
:ENABle?
[:EVENt]?
:NTRansition < transition_mask >
:NTRansition?
:PTRansition < transition_mask >
:PTRansition?
The Status system contains four status groups
•
Operation Status Group
•
Questionable Data Group
•
Standard Event Group
•
Status Byte Group
This SCPI STATus subsystem communicates with the first two groups while
IEEE-488.2 Common Commands (documented later in this chapter) communicate
with Standard Event and Status Byte Groups.
SCPI SCPI Event
Enable Registers
Registers
preset clear
none none
none clear
preset none
IEEE 488.2 IEEE 488.2
Registers Registers
ESE and SRE SESR and STB
clear clear
none none
none clear
none none
Chapter 6