Table of Contents
Advertisement
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
ACCELERATOR PEDAL LIMIT SWITCH
See General Warnings on page 1-2.
TESTING THE ACCELERATOR PEDAL LIMIT SWITCH
See Test Procedure 7 – Throttle Position Sensor (TPS) on page 18-20.
The accelerator pedal limit switch is housed inside the throttle position sensor. The throttle position sensor itself is not
intended to be replaced. If sensor is determined to need replacing through test procedures found in this manual, the
accelerator pedal assembly must be replaced.
KILL LIMIT SWITCH
See General Warnings on page 1-2.
TESTING THE KILL LIMIT SWITCH
See Test Procedure 7 – Throttle Position Sensor (TPS) on page 18-20.
The kill limit switch is housed inside the throttle position sensor. The throttle position sensor itself is not intended to be
replaced. If sensor is determined to need replacing through test procedures found in this manual, the accelerator
pedal assembly must be replaced.
REVERSE WARNING BUZZER
See General Warnings on page 1-2.
TESTING THE REVERSE WARNING BUZZER
See Test Procedure 16 – Reverse Buzzer and Reverse Buzzer Limit Switch on page 18-30.
REVERSE WARNING BUZZER REMOVAL
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
2.
Remove the instrument panel. See Key Switch Removal on page 19-18.
3.
Disconnect the wires from the reverse warning buzzer (2) (Figure 19-21, Page 19-24).
4.
Remove the two mounting screws (3) securing the buzzer to the instrument panel.
2019 Precedent Villager 2 Maintenance and Service Manual
Accelerator Pedal Limit Switch
19
Page 19-23
Advertisement
Table of Contents
Troubleshooting
