Insert Label Roll In Labeler - Weber Geset 125 Original User Manual

Chapter 7 Adjustment and initial operation
Requirements

Power supply is turned off.

No transportation of products.

Sample product
Instruction
Please adjust the height of the wrapping unit as follows.
Step
1
2
3
4
5
Please adjust the lateral position of the wrapping unit as follows.
Step
1
2
3
4

Insert label roll in labeler

Detailed information on adjustment of the labeler is described separately in provided
manual!
Additionally there is a threading pattern sticked on each labeler that shows the guiding of
the label web. Thread the label web accordingly. Please observe that for each labeler and
the product to be labeled, there will be inserted the correct label roll.
Version: 30.07.14
Procedure
Loosen the clamping to height adjustment (Pos. 2, Fig. 7-6) of the wrapping
unit.
Place a sample product between roll conveyor and wrapping unit.
Adjust the wrapping unit with the crank for lateral adjustment (Pos. 1, Fig.
7-6) to the required criteria (s. section above). Information on positioning
equipment s. from page 33.
Tighten the interlock for height adjustment (Pos. 2, Fig. 7-6).
Check and correct this adjustment if applicable.
Procedure
Loosen the clamping to lateral adjustment (Pos. 4, Fig. 7-6) of the wrapping
unit.
Adjust the wrapping unit with the crank for lateral adjustment (Pos. 3, Fig.
7-6) to the required criteria (s. section above). Information on positioning
equipment s. from page 33.
Tighten the interlock for lateral adjustment (Pos. 4 Fig. 7-6).
Check and correct this adjustment if applicable.
Page 39 of 57
40001136 Geset 125
GB