Table of Contents
Advertisement
Chapter 8 Operation
Putting the system out of service
The label material running around the deflection rollers is curved which can cause
problems with the operation mode. This characteristic of the labels as well as the retained
curvature depend on the material which can vary significantly between the different print
media. The ambient conditions such as high temperatures and humidity enhance this
effect.
Remove critical label material before long breaks and after end of work from
labeler!
Instruction
Please put the label system out of service as follows.
Step
1
2
3
4
5
Version: 12.05.14
When turning off the system for several hours, the label web must
be removed from the labeler to avoid failures at re-start.
Procedure
Stop labeling operation (s. Seite Stop labeling operation).
Disconnect the power supply.
Protect the labeling station if applicable from dust with a cotton or linen cloth.
If the labeling system should be stored and/or transported, please observe
the notes referring...
Transport (page 24)
Storage conditions (page 27)
Transport the labeling station like described in chapter „Transportation and
unpackaging" to its storage location.
Page 41 of 56
40001684 Geset 111
GB
Advertisement
Table of Contents
