To Set Wave Type And Parameters - Teledyne T3DSO2000 Series User Manual

Setting the Waveform Type and Parameters
1. Press the WaveGen button on the front panel to open the built-in arbitrary waveform
generator function. The first press lights up the backlight of the button, opens the
output and enters the WAVEFORM function menu. A second press of the WaveGen
button will turn off the backlight and the output.
2. Press the Wave Type softkey; then turn the Universal Knob to select the desired
waveform and push the knob to confirm. Press the Wave Type softkey continually
can also select the waveform type.
3. Press the Frequency softkey; then turn the Universal Knob to select Frequency,
Frequency Fine, Period or Period Fine and push the knob to confirm; turn the
Universal Knob to select the desired value. Use the same method the set the other
parameters.
Wave
Type
Sine
Square
Ramp
pulse
1.800.561.8187
181
Character
Use the Universal Knob to
adjust the Frequency / Frequency
Fine / Period / Period Fine /
Amplitude / Amplitude Fine /
High-Level / High-Level-Fine /
Offset / Offset Fine / Low-Level /
Low-Level-Fine value.
Use the Universal Knob to
adjust the Frequency / Frequency
Fine / Period / Period / Fine /
Amplitude / Amplitude Fine /
High-Level / High-Level-Fine /
Offset / Offset Fine / Low-Level /
Low-Level-Fine / Duty value.
Use the Universal Knob to
adjust the Frequency / Frequency
Fine / Period / Period Fine /
Amplitude / Amplitude Fine /
High-Level / High-Level-Fine /
Offset / Offset Fine / Low-Level /
Low-Level-Fine / Symmetry
value.
Use the Universal Knob to
adjust the Frequency / Frequency
Fine / Period / Period / Fine /
Amplitude / Amplitude Fine /
High-Level / High-Level-Fine /
www.
Frequency Amplitude
Range (High-Z)
1uHz~25MHz 4mV~6V
1uHz~10MHz 4mV~6V
1uHz~300KHz 4mV~6V
1uHz~10MHz 4mV~6V
information@itm.com
.com
Offset
(High-Z)
± 3.0V
± 3.0V
± 3.0V
± 3.0V