Running Video Pattern Tests; Selecting A Signal Type - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
7

Running Video Pattern Tests

This section provides the Instructions for running video tests on the 804/804A/804B. Procedures are provided for operation
both through the front panel and the command line.
Note: If the 804/804A/804B is used in a manner not specified in the guide, the protection provided by the equipment may be
impaired.
7.1

Selecting a Signal Type

Use the information in Table 7-1 below as a guide:
Table 7-1: Signal Type
Signal Type Menu Selection
HDMI
DVI
VGA(HD15) Analog YPbPr
VGA(HD15) Analog RGB
BNC + S-Video + CVBS
1. Power up the 804/804A/804B using the rocker switch on the back panel and the front panel. The On position is with the
toggle switch depressed on the inner side of the switch.
Refer to the procedures in the section
2. Make the cable connection between the appropriate output connector(s) on the 804/804A/804B and the input connectors
of the HDTV using the cables supplied. Refer to the figure below to view the locations of the video outputs.
Page 23
Physical Connector(s)
HDMI via HDMI to HDMI cable (available
with optional cable kit)
HDMI via HDMI to DVI cable (available with
optional cable kit)
HD-15 (VGA) via VGA cable to 3 RCA
converter cable (available in the optional
cable kit)
HD-15 (VGA) via VGA cable (available in
the optional cable kit)
CVBS (BNC) and S-Video
(3) BNC (ED/HD)
Instructions for
Option
Color Space
Bit Depth
Format Type
Format Type
Sync Type
Format Type
Sync Type
Format Type
Use.
Output Selections
RGB

YCbCr 4:4:4

YCbCr 4:2:2

 YCbCr 4:2:0 (804A for 4K formats @ 60Hz)
 8
 10
 12
 TV – CE formats
Computer – VESA formats

 TV – CE formats
Computer – VESA formats

Sep[arate] Sync

Sync on Y

 TV – CE formats
 Computer – VESA formats
 Sep[arate] Sync
 Sync on Green
 SD – TV composite video (NTSC & PAL
formats)
 ED/HD – TV formats for component video
Revision B3