I/O Set; To Set The Usb Device - Teledyne T3DSO2000 Series User Manual

I/O Set

T3DSO2000 provides abundant I/O interfaces, including: USB Device, LAN and Aux
Output.

To Set the USB Device

Do the following steps to set the oscilloscope to communicate with PC via USB:
1. Install the USBTMC device driver on a PC. The latest compatible version of
National Instruments VISA is suggested.
2. Connect the oscilloscope with the PC using a standard USB cable
3. Press the Utility button on the front panel to enter the UTILITY function menu.
4. Press the I/O Set softkey to enter the I/O SET function menu.
5. Press the USB Device softkey to select USBTMC.
6. Use NI-MAX to communicate with the oscilloscope.
Do the following steps to set the oscilloscope to print the screen image:
1. Connect the oscilloscope to a printer using a standard USB cable.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the I/O Set softkey to enter the I/O SET function menu.
4. Press the USB Device softkey to select Printer.
5. Press the Print button on the front panel to print the screen image.
1.800.561.8187 information@itm.com
167
www. .com