Table of Contents
Advertisement
To Set Display Type
Press the Display button on the front panel, and then press the Type softkey to select
Vectors or Dots display type.
●
Vectors: the sample points are connected by lines and displayed. Normally, this
mode can provide the most vivid waveform to view the steep edge of a waveform
(such as a square wave).
●
Dots: displays only the sample points . You can directly view each sample point and
use the cursor to measure the X and Y values of the sample points.
Figure 72 Vectors Display
Figure 73 Dots Display
User Manual 139
Advertisement
Table of Contents
