Can Trigger And Serial Decode; Setup For Can Signals - Teledyne T3DSO2000 Series User Manual

CAN Trigger and Serial Decode

The following section describes trigger and decoding for the CAN bus and is
organized as follows: 'Setup for CAN Signals', 'CAN Triggering' and 'CAN Serial
Decode'.

Setup for CAN Signals

1. Press the Decode key to enter the DECODE function menu.
2. Press the Decode softkey and select the desired slot (Decode1 or Decode2).
3. Press Protocol softkey and then select CAN by turning Universal Knob.
4. Press Signal softkey to enter the SIGNAL menu as Figure 52 shows.
5. Set CAN-H:
a.
b.
6. Set CAN-L:
a.
b.
7. Press the Configure softkey to enter the BUS CONFIG menu.
8. Press Baud to set baud rate by the Universal Knob.
�� The baud rate can be set as a predefined value (from 5kb/s to 1Mb/s) or custom
1.800.561.8187
100
Figure 52: CAN SIGNAL Menu
Press CAN-H softkey to select the channel that is connected to the CAN-H
signal.
Press first Threshold key to set the CAN-H signal threshold voltage level by the
Universal Knob. The threshold voltage level is for decoding, and it will be
regarded as the trigger voltage level when set the trigger type to serial.
Press CAN-L to select the channel that is connected to the CAN-L signal.
Press second Threshold key to set the CAN-L signal threshold voltage level by
the Universal Knob. The threshold voltage level is for decoding, and it will be
regarded as the trigger voltage level when set the trigger type to serial.
value (from 1b/s to 1Mb/s).
www.
information@itm.com
.com