Option Management - Teledyne T3DSO2000 Series User Manual

Option Management

The T3DSO2000 provides multiple options to fulfil your measurement requirements.
Please contact your sales representative or technical support to order the
corresponding options. You can view the options currently installed on the
oscilloscope or activate the newly purchased option license codes through this menu.
Do the following steps to install the option on the oscilloscope:
1. Press the Utility button on the front panel to enter the UTILITY function menu.
2. Press the Next Page softkey to go to the second page of the UTILITY function menu.
3. Press the Next Page softkey to go to the third page of the UTILITY function menu.
4. Press the Options softkey to enter the OPTION function menu.
5. Press the Type softkey; then turn the Universal Knob to select the module to be
installed and push the knob to confirm.
6. Press the Install softkey to enter the LABEL function menu to input the license.
7. Press the Information softkey to view the option information.
1.800.561.8187
Figure 99: OPTION Function Menu
Figure 100: LABEL Function Menu
� Turn the Universal Knob to select character
�
Push down the Universal Knob to confirm the characters
�
Press the Press To Install when license key input done, the screen will
pop-out the message 'The license key is installed'.
�
Press the Clean softkey or the Backspace softkey to delete the incorrect
character.
www.
information@itm.com
.com
203